Hardinge-Koppers 12 x 5 Sag Mill ID: 169964

• 12 ft dia. x 5 ft.
• Self aligning bearings.
• Brass inserts.
• rubber seals.
• Bearing sole plates.
• Single helical bull and pinion gear.
• 318 tooth Bull Gear.
• 16 tooth Pinion gear.
  • Spare used pinion gear.
• Louis Allis 250 HP electric motor.
• 460 volt.
• 3 Phase.
• 60 HZ.
• 1180 RPM.
• 449TS Frame.
• Control Panel
• Falk parallel shaft gear reducer.
• Model 2100Y1-S.
• 3.542 - 1 ratio.
• Air clutch.
• Internal Grate discharge.
• External Trommel discharge
• Girth gear guarding
  • With spray Lubrication system.
• Individual Bearing gear Lubrication system.
• Brown and Sharpe gear pumps.
• Existing Liners.
• • Includes Carrier 54-290 Reciprocating trough feeder
  • Belt drive with electric motor.
• Shipping cradles.

Henan Shibo 2PG400X250 Double Roll Crusher ID: 1424568

Henan Shibo 2PG400X250 Double Roll Crusher

• Make: Henan Shibo Mechanical Engineering Co.
• Model: 2PG400X250
• Condition: Used, Reported in Good Condition 
• Hours: Less Than 40 Hours Use
• Number of Rolls: 2 Rolls
• Capacity: 5-15 TPH
• Roll Diameter: 400mm (15.7in)
• Roll Length: 250mm (9.8in)
• Teeth Material: ZGMn13
• Max Feed Size: 25mm
• Discharge Size: 2-8mm
• Compression Strength: 180 MPa
• Comes with Channel Steel Stand With Fork Pockets and Stairs
• Drive: (2) Electric Motors
  • Power Output: 5.5kW
  • Roller Speed: 180 RPM 
  • Voltage: 600 Volts
  • Frequency: 60Hz
  • Phase: 3-Phase
    
    
• Overall Dimensions: Crusher Only
  • Length: 1,837.5mm (72.3in)
  • Width: 1,904mm (75in)
  • Height: 1,001mm (39.4in)
  • Weight: 1.5 Tons
    
    
• Location: Eastern Canada

View More Roll Crushers